CVE-2026-98784NONE
EPSS 0.2%
In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu/gfx6: fix firmware leak on teardown
The firmware requested in gfx_v6_0_init_microcode() is not released
when the GFX block is torn down, leaking the firmware resources.
Add gfx_v6_0_free_microcode() and call it from gfx_v6_0_sw_fini()
to release the PFP, ME, CE and RLC firmware.
(cherry picked from commit 386e81346f95ab0be5a82c5535de932e7a456924)
CVE-2026-98794NONE
EPSS 0.2%
In the Linux kernel, the following vulnerability has been resolved:
ipvs: filter some flags received in the backup server
While the IPVS SYNC protocol is not secure by design
we can still protect the backup server from messages that
can wreak havoc.
This commit addresses problems from received connection flags
or their combinations. We now drop messages as follows:
1. the NO_CPORT+TEMPLATE combination allows lookups for normal
connections to hit template which can break in many ways.
While the master does not sync connections with NO_CPORT flag,
i.e. before they are established, we still accept NO_CPORT
without TEMPLATE.
2. ONE_PACKET: it is not sent by master, so we do not
expect it in backup. Before now it was ignored by
IP_VS_CONN_F_BACKUP_MASK for protocol v1 while protocol
v0 created connections that are not hashed and dropped
immediately. Better to apply the IP_VS_CONN_F_BACKUP_MASK
also to the flags from v0 messages for consistency with v1.
CVE-2026-98856NONE
EPSS 0.2%
In the Linux kernel, the following vulnerability has been resolved:
kprobes: Skip disarmed probes when checking optkprobe overlap
On x86, an optkprobe at A replaces five bytes with a jump. If a disabled
probe B is at A+2, get_optimized_kprobe() stops at B when arming a new
probe C at A+4. It leaves A optimized:
A A+1 A+2 A+3 A+4
A's jump | e9 | d0 | d1 | d2 | d3 |
after C | e9 | d0 | d1 | d2 | cc |
The INT3 for C overwrites the last byte of A's jump displacement, so
execution can jump to the wrong address. B can have prepared optinsns
while disarmed, but has no jump to unoptimize.
Continue past disarmed and unprepared probes to find the active optimized
probe before arming a probe in its jump.
CVE-2026-98568NONE
EPSS 0.2%
In the Linux kernel, the following vulnerability has been resolved:
vxlan: use one headroom snapshot for neighbour replies
vxlan_na_create() samples LL_RESERVED_SPACE() to size the reply skb and then
samples it again to reserve headroom. A concurrent vxlan_changelink() can
update needed_headroom between the two reads, creating a TOCTOU race. The
second value can exceed the allocation and make the Ethernet header write out
of bounds.
The race is reproducible on the unpatched kernel. It occurred when
vxlan_na_create() generated a neighbour reply while vxlan_changelink() changed
the link headroom. KASAN caught a four-byte write two bytes beyond a 704-byte
skbuff_small_head allocation.
Snapshot the headroom once and use that value for both allocation and
reservation.
CVE-2026-98725NONE
EPSS 0.2%
In the Linux kernel, the following vulnerability has been resolved:
nvmet-auth: fix out-of-bounds write in nvmet_auth_challenge()
nvmet_auth_challenge() receives its output buffer as a void pointer.
sizeof(*d) therefore evaluates to one with GCC and undercounts the fixed
challenge header by 15 bytes. A short AUTH_RECEIVE buffer can pass the
check before the challenge is copied past the end of its allocation.
Use the typed challenge pointer when calculating the response size.
BUG: KASAN: slab-out-of-bounds in nvmet_execute_auth_receive (drivers/nvme/target/fabrics-cmd-auth.c:442 drivers/nvme/target/fabrics-cmd-auth.c:569)
Write of size 32 by task kworker/1:1H/64
Workqueue: nvmet_tcp_wq nvmet_tcp_io_work
Call Trace:
nvmet_execute_auth_receive (drivers/nvme/target/fabrics-cmd-auth.c:442 drivers/nvme/target/fabrics-cmd-auth.c:569)
nvmet_tcp_try_recv_pdu (drivers/nvme/target/tcp.c:1119 drivers/nvme/target/tcp.c:1243)
nvmet_tcp_io_work (drivers/nvme/target/tcp.c:1350 drivers/nvme/target/tcp.c:1382 drivers/nvme/target/tcp.c:1445)
process_one_work (kernel/workqueue.c:3322)
worker_thread (kernel/workqueue.c:3405 kernel/workqueue.c:3486)
kthread (kernel/kthread.c:436)
ret_from_fork (arch/x86/kernel/process.c:158)
ret_from_fork_asm (arch/x86/entry/entry_64.S:245)
The buggy address is located 16 bytes inside of
allocated 33-byte region [ffff888000554e80, ffff888000554ea1)
Kernel panic - not syncing: KASAN: panic_on_warn set ...
CVE-2026-98664NONE
EPSS 0.2%
In the Linux kernel, the following vulnerability has been resolved:
iio: imu: adis16400: fix unprotected debugfs reads
adis16400_serial_number_fops is open coded and never calls
debugfs_file_get(), so debugfs_remove_recursive() does not wait for a
read in progress and unbind frees the iio_dev underneath it.
Commit ae1d37a9bb4b ("iio: imu: adis16400: use DEFINE_DEBUGFS_ATTRIBUTE
instead of DEFINE_SIMPLE_ATTRIBUTE") converted product_id and
flash_count to DEFINE_DEBUGFS_ATTRIBUTE, which protects itself, but
moved all three files to debugfs_create_file_unsafe().
serial_number prints three registers as "%.4x-%.4x-%.4x" and
DEFINE_DEBUGFS_ATTRIBUTE() formats a single u64, so it cannot be
converted without changing what the file returns. adis16475 and
adis16550 already use debugfs_create_file() for their open coded
files. Use it here too.
CVE-2026-98695NONE
EPSS 0.2%
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: fix ioctl hangup race
The tty ioctls can race with hangup and end up calling into a tty driver
for a device that is already gone or powered down.
Serialise the callbacks using the tty port mutex and add the missing
checks to make sure the port has not been hung up before accessing port
driver data or hardware.
This specifically avoids dereferencing a NULL-pointer if a device is
disconnected during lengthy break signalling.
Note that TIOCGICOUNT and TIOCMIWAIT do not access port driver data or
hardware and are therefore not affected by the race.
CVE-2026-98705NONE
EPSS 0.2%
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: account proxy paths against the mesh path limit
Proxy-path churn can drive the interface path counter negative and let
later mesh path additions exceed MESH_MAX_MPATHS.
mesh_path_free_rcu() decrements the interface mpaths counter for entries
from both the mesh and proxy path tables, but mpp_path_add() never
reserves a slot in that counter. Removing or expiring a proxy path
therefore returns a slot that was never charged.
mesh_path_add() uses the same counter to enforce MESH_MAX_MPATHS, so once
it falls below the number of installed paths the limit no longer holds.
Reserve the shared quota before allocating a proxy path and release it on
every unsuccessful addition. Mesh and proxy paths now share one
1024-entry budget, so mpp_path_add() can return -ENOSPC at that limit.
CVE-2026-98721NONE
EPSS 0.2%
In the Linux kernel, the following vulnerability has been resolved:
mtd: rawnand: cadence: Initialize IRQ state before requesting IRQ
The Cadence NAND interrupt handler uses both the IRQ lock and completion
object. Registering the IRQ before initializing them leaves a window in
which a pending interrupt can access uninitialized synchronization state.
Initialize them before registering the handler.
CVE-2026-98726NONE
EPSS 0.2%
In the Linux kernel, the following vulnerability has been resolved:
nvme-multipath: fix underflow in ANA log bounds checks
The number of ANA groups advertised through Identify Controller sizes the
ANA log buffer. The ANA log header and group descriptors independently
supply the number of groups and namespace IDs to parse.
Both bounds checks subtract an untrusted object size from ana_log_size
before comparing the current offset. If the object is larger than the
buffer, the size_t subtraction underflows and lets the parser read beyond
ana_log_buf.
Check the current offset before the first subtraction and compare each
object size with the remaining buffer instead. This rejects inconsistent
ANA data before dereferencing a truncated group descriptor or walking an
oversized namespace ID array.
CVE-2026-98837NONE
EPSS 0.2%
In the Linux kernel, the following vulnerability has been resolved:
ALSA: caiaq: unregister the input device when probe fails
setup_card() registers the input device, whose name and phys point into
struct snd_usb_caiaqdev, and then goes on to snd_card_register() and
snd_usb_caiaq_control_init(). If either fails, snd_probe() calls
snd_card_free(), which frees the device state but leaves the input
device registered: card_free() only clears the pointer, and the input
device is unregistered from snd_disconnect() alone. Reading its "uevent"
attribute afterwards dereferences freed memory:
BUG: KASAN: slab-use-after-free in string+0x4a9/0x4f0
Read of size 1 at addr ffff8880208f5043 by task caiaq/4967
add_uevent_var+0x183/0x3a0
input_dev_uevent+0x162/0x900
dev_uevent+0x2f1/0x870
uevent_show+0x1ca/0x3a0
...
Unregister the input device on the probe error path, as
snd_disconnect() does. snd_usb_caiaq_input_disconnect() is a no-op when
no input device was registered.
Reproduced with a raw-gadget Audio Kontrol 1 and a temporary hack that
makes snd_usb_caiaq_control_init() fail.
CVE-2026-98851NONE
EPSS 0.2%
In the Linux kernel, the following vulnerability has been resolved:
netfilter: nft_flow_offload: drop flowtable reference on init error path
nft_flow_offload_init() bumps the flowtable use count with
nft_use_inc() before calling nf_ct_netns_get(). When the latter
fails, the error is returned as-is and the reference is leaked.
The upper layers do not balance it either: nf_tables_newexpr()
clears expr->ops when the expression init callback fails, so the
nft_expr_more() iteration in nft_rule_expr_deactivate() and
nf_tables_rule_destroy() stops right before the failed expression
and its ->destroy callback, which would drop the reference, never
runs.
Each failed rule addition therefore leaks one flowtable reference
and the flowtable can no longer be removed: NFT_MSG_DELFLOWTABLE
keeps reporting -EBUSY even though no rule references it.
Save the nf_ct_netns_get() return value and undo the nft_use_inc()
when it fails, restoring the inc/dec pairing within
nft_flow_offload_init() itself.